Expert Answers in Ceramic and Porcelain Tile

ANSWER - It is hard to see exactly what they did.  Your message says “photo thin set 1/16” is on the floor, 1.5” to 2.5” of mortar mix with less than 90% coverage, and thin-set 1/16”…

ANSWER - ANSI A108.02 are the standards for tile installer workmanship.  Some of the standards are quantitative, but many are qualitative and subjective. The only reference to alignment is that the tile should be installed…

ANSWER - First you need to determine what caused the smudges on the tile in order to determine how to remove them. If you have a polished porcelain tile there is a condition known as…

ANSWER - There are rapid setting concrete mixes that can be purchased like QUIKRETE® Fast-Setting Concrete Mix.  It sets up within an hour, but doesn't stop shrinking right away.  If you heat up the area, some…

ANSWER - There are epoxy adhesives that you can use to install the ceramic porcelain tile over a properly prepared epoxy floor. First you have to make sure that the existing epoxy floor is well…

ANSWER - If the ceramic tile was installed correctly and the water wasn't contaminated, then the tile should not have been damaged from the flood incident. Since the tile is installed over a concrete substrate…

Answer: First of all, all of the transition joints in the shower both horizontal and vertical should not have been grouted with a cementitious grout.  They should have been filled with an ASTM C920 resilient sealant…

ANSWER - It sounds as though your tile installation has failed and is debonding. It is likely due to compounding deficiencies in how it was installed. The substrate may have not been properly prepared. The tile…

ANSWER - It sounds as though your tile installation has failed and is debonding.  It is likely due to compounding deficiencies in how it was installed.  The substrate may have not been properly prepared.  The…

Answer - Unfortunately when you acid etch the surface of a glazed tile it chemically alters the glaze and it can't be restored. If the etched area is contrasting in color to the tile color,…