Expert Answers in

ANSWER – The standards for a porcelain tile is that the substrate can not have more deflection than L/360.  For natural stone over a wood subfloor it is L/720.  L stands for the…

ANSWER – First of all what happen to the the 3rd wall in the shower?  I will assume it has a different substrate or you aren’t tiling it.

Not sure why you are using Schluter…

ANSWER – As long as the linoleum is well attached to its substrate, and the substrate is structurally sound, then you can install tile over it.  The new tile installation will only be as good…

There should be a 1/8″ joint between the wood and marble.  It would be best to caulk that joint as there is likely to be movement.   If you don’t have a joint then when the…

ANSWER – It is hard to see exactly what they did.  Your message says “photo thin set 1/16” is on the floor, 1.5” to 2.5” of mortar mix with less than 90% coverage, and thin-set 1/16”…

ANSWER – ANSI A108.02 are the standards for tile installer workmanship.  Some of the standards are quantitative, but many are qualitative and subjective.

The only reference to alignment is that the tile should be installed…

ANSWER – First you need to determine what caused the smudges on the tile in order to determine how to remove them.

If you have a polished porcelain tile there is a condition known as…

ANSWER – There are rapid setting concrete mixes that can be purchased like QUIKRETE® Fast-Setting Concrete Mix.  It sets up within an hour, but doesn’t stop shrinking right away.  If you heat up the area, some…

ANSWER – Generally speaking they say that it takes 28 days for a concrete slab to cure under favorable climatic conditions.  If the concrete is not as thick and the temperatures are higher with the…

ANSWER – There are epoxy adhesives that you can use to install the ceramic porcelain tile over a properly prepared epoxy floor.

First you have to make sure that the existing epoxy floor is well…