ANSWER - I am not aware of any Sealers or Stains that are latex based. Normally the sealers are a silicone based material or a solvent. Depending on what type of stain you are referring…
ANSWER - There should not be a grout film left on the surface of the tile. If the installer had been careful and cleaned it properly it could have been avoided. If the grout is cement…
ANSWER - What you use to remove the grout residue from a porous terracotta tile that was not removed during the installation process as it should depends on what kind of grout was used. A standard…
ANSWER - Normally when a sealer turns cloudy, particularly if it isn't a breathable sealer, it is because the tile has excessive moisture within it. To remove the sealer you have to use a stripper…
ANSWER - Sorry to hear about your epoxy grout problem. It should have been finished by the installer in a manner so it was smooth and would not tend to pick up dirt and would…
ANSWER - I'm not sure if you are saying that your bone color grout is dirty and you can't get it to clean or if your ceramic tile is dirty and you can't get it clean. …
ANSWER - There are grout colorants that allow you to change the color of your grout to almost any grout color. They are epoxy based, and it is a tedious process. First, you must make…
ANSWER - Grout joint width depends on how consistent is the size dimensions of the tile and how flat is the substrate it is being attached to. Should always have at least 1/8" wide grout…
ANSWER - Normally when there is a problem it is the result of compounding factors that each contribute to the problem to some degree. The grout was likely over watered when mixed and during the…
ANSWER - Cracking grout is a symptom that there is excessive movement in the tile. The excessive movement could be caused by too much deflection within the floor. The industry standard is that the deflection…